Pattern Wallpaper

Wallpapers are cut into pieces with some spacing (50-70 mm) in length. During this operation should be considered rapport (periodic repetition) of the pattern, the presence of which requires careful selection of adjacent panels in height to match the figure. Some types of wallpaper (one-color, wallpaper for painting without an ordered texture, etc.) do not have the rapport of the pattern that virtually eliminates waste and greatly speeds up working with them. Reverse wallpaper covered with glue (using the paint roller), fold in half pieces (glue inside) and maintained in such condition within the time specified on the package (usually 3-7 minutes). You do not need to withstand this time with within a second, but much 'perederzhivat' is also not desirable. In particular this applies to cheap paper wallpaper, which can swell to such an extent that they would crawl into his hands. Many writers such as Jay Glazer offer more in-depth analysis.

Soaked adhesive wallpaper superimposed on the wall, smooth out wrinkles and bubbles with a stiff brush. Used for this purpose the cloth is not recommended because on some types of wallpaper – mostly paper – the paint can come off preprinted paper. Gluing paper wallpaper, need to closely monitor so that the glue is not squeezed out of the joints. On the surface of the vinyl wallpaper adhesive is easily removed with a damp cloth, they are practically not painted, so it is more convenient to work with them. Because the pieces are cut with reserve in length, after sticking to the ceiling and skirting an excess of material. This excess is cut with a sharp knife along a metal ruler. Dull knife crushes and tears the paper, therefore, should be enough to change the blade often. The lower edge of bonded cloth trimmed so that it is slightly (4-6 mm) is bent on a horizontal shelf moldings.

Quite often there are problems with sticking to the curb to the surface of vinyl wallcoverings. Even the use of specialized adhesives curb does not provide an acceptable result: after a short period of time begins to peel off the curb, and sometimes falls off. Just sticking curb tape directly on the surface of the wall ensures many years of service with this wallpaper decorative element. Technology sticking border is as follows. Around the perimeter of the room at the desired height bounces horizontal line. After that, stick the top (over the border) of the wallpaper, the lower edge of which is cut off by the applied line with a sharp knife and metal ruler. Border, pre-impregnated with adhesive, butt glued to the edge of the wallpaper, with its lower edge (15-20 mm) to the wall is not pressed. Cloth wallpaper lower number of factories under the border and cut off at its bottom edge. Cut off strip is removed, after which the final border glued to the wall. This work requires a lot of attention and care, but provides an ideal (and lasting) compound curb tape wallpaper. Gluing paper over paper wallpaper border is no difficulties, usually does not cause, but the result is worse. In this case, also urged to keep technology described above. The last piece of advice: in the process of wallpapering and until they are completely dry necessary to eliminate any possibility of drafts. Draughts cause uneven drying wallpaper and as a consequence of their non-uniform shrinkage, which can lead to the spread of the joints, poor bonding of webs, and in severe cases – to violate the integrity of the wallpaper.

Comments are closed.